KaiMBR - Membrane Bio Reactor

KaiMBR submerged modules are used for Membrane Bioreactor (MBR) processes. Submerged MBR process is most often used to treat municipal/industrial wastewater but can be used in drinking water applications as well. KaiGO’s product line includes options that vary the fiber thickness to optimize the product selection depending on the application.


  • Symmetric TIPS PVDF technology eliminates the risk of delamination and minimizes the impact of abrasion
  • Long membrane life due to high mechanical and superior chemical strength
  • Double decker skid design leads to lower energy consumption
  • High permeability due to permanent hydrophilicity
  • Stable high flux reduced fouling
  • Minimum footprint due to double decker skid design
  • Extreme pH and oxidant tolerance to remove severe fouling and restore performance


Model no KaiMBR T1510 KaiMBR T2215 KaiMBR T3020
Pore size 0.04um 0.04um 0.04um
Filtration area 15m2 22m2 30m2


Hydranautics offers a wide range of ultrafiltration and microfiltration modules based on polymeric hollow fibers. All membranes solutions offered can be used as a replacement of conventional treatment systems combining benefits of high permeate quality and low footprint requirements. Using Hydranautics ultrafiltration products, RO membranes may be used downstream more safely while operating at higher fluxes with longer intervals between cleans.


  • High performance membrane elements ideal for high purity water
  • Ultra low pressure, energy saving brackish water membranes
  • Hollow fiber membrane for membrane bioreactor applications
  • Low Fouling
  • High rejection membranes


UF NF RO Process Separation Membrane Elements
HYDRACAP ESNA SWC – Sea Water Composite Daily RO series
HYDRACAP MAX NANO – BW CPA – Composite Polyamide Daily NF series
HYDRASUB NANO – SW ESPA – Energy Saving Polyamide Dairy UF series
- HYDRA Core LFC – Low Fouling Composite San RO
- - - HYDRA pro

KaiCF - Micron Cartridge Filter

KaiCF cartridge is constructed of thermally bonded polypropylene microfibers to ensure high efficiency. The filter incorporates a rigid polypropylene center core for increased collapse strength and durability. This thermal bonded micro-fiber construction has minimal fiber release, consistent flow rate and superior filtration performance. It is also not brittle or prone to breakage problems like resin-bonded cartridges. Unique micro-grooves provide added surface area. The recommended temperature limit of 40° F to 175° F allows it to be used in many hot water applications.


  • Free of surfactants, binders and adhesives
  • Excellent flow with low pressure drop
  • High dirt holding capacity
  • 100 % Polypropylene for wide chemical compatibility
  • High strength & pressure resistance
  • Will not impart taste, odour or colour to the liquid being filtered
  • One piece construction up to 1016 mm & more


  • Available in Spun & Wound type construction
  • 1 to 50 Micron rating
  • Available from 10”, 20”, 30” & 40” Length and 2.5”, 4” & 4.5” Dia